SUPERBUY SPREADLIVE
← Back to the edit

FIELD NOTE 01 / FIT

Two measurements.
A clearer decision.

Shopping from Australia? Check the seller’s garment measurements against a piece you like wearing, in centimetres or inches. Use your chosen tolerance to spot which measurement needs a closer look.

Flat garment comparison

Your garment
Seller’s garment

Applied separately to width and length. This is your preference, not a seller’s manufacturing tolerance.

The fit check and readiness notes are stored only in your browser. No account is needed.

Measurement difference

Enter all four measurements and a tolerance to compare.

A positive number is larger; a negative number is smaller. Flat chest width is not a full chest circumference.

This comparison cannot account for stretch, fabric, cut, shrinkage or measuring error. It does not select a size or guarantee a fit.

An example, not a sizing rule

Your tee is 54 cm wide and 70 cm long. The listing says 56 cm and 71 cm. At a tolerance of 1.5 cm, the width falls outside your preference while the length is within it. That tells you which measurement needs attention.

01

Choose your reference

Pick a garment you like wearing in the same category. A fitted tee is a poor reference for a heavy jacket worn over layers.

02

Match the method

Lay both garments flat. Measure chest width from underarm to underarm; check where the seller starts the length measurement. Never compare a flat width directly with a full circumference.

03

Ask about the difference

If the chart says 56 cm across the chest and your garment is 54 cm, the difference is +2 cm in flat width. Decide whether that extra room suits the cut; do not treat it as a body measurement.

04

Confirm the actual piece

A size chart describes the listing. Ask for a ruler photo of the selected size if the decision depends on a small difference. Check the ruler’s zero point and that the fabric is not stretched.

Read the listing, not just the photo.